We’re open 9:00am - 5:00pm Mon-Fri
BIOCHECK BB PACK
The BIOCHECK BB PACK is available in Matt or Silk and either White or Magnolia. This handy pack of BIOCHECK EMULSION PAINT which contains unique biocides which prevent the growth of mould on walls and ceiling even in properties suffering from extreme condensation and was developed specifically for use in kitchens and bathrooms, the areas where the maximum amount of condensation is generated.
The BIOCHECK BB PACK contains 200 mls of RLT BACTDET 05 which is used to kill and clean the mould growth off the contaminated surfaces. Dilute at 1:4 with water and apply by brush, cloth or sponge.
Sufficient material for 10-12 square metres of treatment.
RLT BACTDET 05 and BIOCHECK EMULSION PAINT are approved under COPR 1986 (as amended) by the Health & Safety Executive (HSE) for both amateur and professional use.
In the Pack there is 2.5 litres of BIOCHECK EMULSION PAINT which is sufficient for two coats covering 10-12 sq m.
Tests carried out by the Building Research Advisory Service show the long term effectiveness of BIOCHECK EMULSION PAINTin preventing the return of mould on surfaces prone to condensation.
For instructions on how to apply, see our videos here
APPLICATION INSTRUCTIONS FOR THE TREATMENT OF MOULD
For dealing with MOULD GROWTH on surfaces such as walls and ceilings, window frames, doors, skirting boards, etc.
STAGE 1: Use the RLT BACTDET 05 to kill and remove surface mould before preparation work.
Areas to be treated: Treat the whole area where mould can be seen. Extend the treatment one metre (3ft) beyond the infected area in all directions on the walls or ceilings. Carpets should be lifted, especially fitted carpets and the flooring cleaned using the RLT BACTDET 05.
Directions: Put 1 measure, by volume, of RLT BACTDET 05 into 4 measures, by volume, of warm water. Take a brush or clean cloth and wash off the mould.
When the solution becomes dirty, make up a new solution. If the cloth or sponge becomes dirty, throw away and use a clean one.
Wallpaper surfaces must be washed prior to stripping. After wallpaper has been removed wash infected area again.
All wallpaper removed should be bagged, sealed and taken from the premises immediately. Allow surface to dry before proceeding.
After washing, gloss painted areas must be etched using sandpaper or similar, before proceeding to Stage 2.
STAGE 2: Decoration
The application of BIOCHECK EMULSION to walls and ceilings is by brush or roller. Two coats are normally required. The first coat may be thinned with approximately 10% clean water. DO NOT THIN THE SECOND COAT.
Wash brushes or rollers thoroughly in plenty of clean water after use.
BIOCHECK must not be mixed with other emulsion paints. Colour tints can be obtained by use of Universal Tinters.
Coverage: The covering capacity of BIOCHECK EMULSION is approximately 12 square metres per litre, per coat, depending on the porosity of the surface.
IMPORTANT: Mould often results from condensation. To lessen the problem ensure adequate ventilation, preferably from a point near the source of the moisture, usually kitchens and bathrooms.
If you require help or assistance with your order including for special colours in Biocheck Matt or Silk Emulsions and Biocheck Allweather please contact our sales office which is open Monday to Friday 9.00 am – 5.00 pm
Telephone: 01372 743334
Fax: 01372 720856
Mould Growth Consultants Limited
Longmead Business Centre
We will aim to process your order for despatch to you between 1-5 working days of confirming acceptance of your order. Consequently, even if you cancel your order shortly after placing it, it is possible that we may be unable to prevent goods you have ordered being despatched to you and you may then need to return them to us at your cost.
When you order your Goods, we will wherever possible, give you an indication of the day of delivery, normally 2-5 working days after confirming acceptance of your order.
Deliveries will be made by post/a carrier instructed by us to the address stipulated in your order. You must ensure that someone is present to accept delivery.
While a delivery date will be prearranged with you, please remember that it is generally not possible to contact the delivery driver once he has left the depot. As a signature is required on delivery, if you will not be at home to take the delivery, a signed note instructing the driver where to leave the goods is acceptable. Otherwise a re-delivery charge will be incurred.
Cancellation of Order
If you bought the Goods as a Consumer, you may cancel your order at any time before we despatch your order or before the expiry of 7 working days from the date you receive your order, not including the day you received it.
As required by the Distance Selling Regulations, details of our after-sales service and guarantees, if any, are given on our website.
If you cancel before we have sent the Goods, we will refund to you the price of the Goods and the cost of delivery, if any.
Our most important task is to ensure your absolute satisfaction. We will always strive to reach that target. However, we acknowledge that mistakes are made occasionally. This paragraph covers that possibility. If you are not wholly satisfied with the product, please tell us at the earliest opportunity:
To do this, it is essential that you follow the instructions below. These provisions apply in the event that you return Goods to us because you say they are faulty:
You must tell us by email message to (email@example.com) or by letter to our land address at the top of this page you that you would like to return Goods, specifying exactly what Goods and when purchased, giving full details of the defect or other reason for return. We will then issue a returns note. If you send Goods to us without a returns note, we may not be able to identify sufficient details to enable us to attend to your complaint.
The Goods must be returned to us as soon as any defect is discovered.
So far as possible, Goods should be returned: